Options
Dead Humax HDR?
beeman
Posts: 91
Forum Member
✭
Humax HDR seems to have stopped working overnight. It was fine last night and as usual put the box into standby.
This morning it wouldn't respond to the remote so turned the box off at the mains. Waited a couple of minutes and turned back on. The front screen lights up and I can hear the hard disk but no text appearson the front screen and the red/blue light on the front does not show.
Message on the TV says "Unsupported signal. Check your device output"
I've swapped boxes and HDMI leads so dish/cables OK.
Any suggestions?
This morning it wouldn't respond to the remote so turned the box off at the mains. Waited a couple of minutes and turned back on. The front screen lights up and I can hear the hard disk but no text appearson the front screen and the red/blue light on the front does not show.
Message on the TV says "Unsupported signal. Check your device output"
I've swapped boxes and HDMI leads so dish/cables OK.
Any suggestions?
0
Comments
Only 3 months old ...:eek:
Easy for the remote to slip into non PVR control mode.
Otherwise it sounds like back to your retailer
Automan.
I've contacted the supplier.
Left it switched off for 24 hours and just before I put it back in the box to return it, I thought I'd give it 1 more try.
It booted and has been working fine.