Humax Foxsat Diseqc Instructions

[Deleted User][Deleted User] Posts: 121
Forum Member
I want to manually tune to a few Italian channels on Hotbird in non-freesat mode while keeping a 2 cable connection in Freesat Mode. I have two dishes, with two cables each going to two DiSeqc switches. How is it done? All Google searches point to http://foxsat-hdr.wikispaces.com/DiSEqC which leads to a page saying "This wiki has been deactivated"!

I have the advanced menu coloured button sequence, but navigation round the menus is booby trapped - It normally results in me losing all the Freesat tuning! Humax so far have not come up with anything. Can anyone help?

Comments

  • REPASSACREPASSAC Posts: 2,017
    Forum Member
    ✭✭✭
    Replied to your post elsewhere.

    Is this any good: http://www.astra2sat.com/freesat/diseqc-settings-on-freesat/
  • [Deleted User][Deleted User] Posts: 121
    Forum Member
    Yes, that looks good. Thanks.

    However, It looks very much like what I have been trying to do. It does not explain why the first antenna signal detected was on DiSEqC C rather than A. I had assumed that the first antenna detection would result in that satellite being allocated to DiSEqC A. I'll have to experiment some more. It may be the reason I keep getting trapped into an unwanted Freesat re-tune, which results in me losing all my recording schedule.

    If anyone can spell out how to avoid being forced into a Freesat re-tune when doing a DiSEqC setup I'd be very grateful.
  • [Deleted User][Deleted User] Posts: 121
    Forum Member
    REPASSAC wrote: »
    Replied to your post elsewhere.
    Where? Or did you you just mean follow the link?
  • REPASSACREPASSAC Posts: 2,017
    Forum Member
    ✭✭✭
    fausto wrote: »
    Where? Or did you you just mean follow the link?

    On another Forum (I don't think posting links to it is allowed here), basically I pasted the same link..
Sign In or Register to comment.