DS Forums

 
 

Humax loss of channels when recording


Reply
Thread Tools Search this Thread
Old 09-02-2010, 08:54
2479steve
Forum Member
 
Join Date: Feb 2010
Posts: 7

Hi
I have just changed from Sky+ to Freesat with a Humax PVR.

All went well with the installation except, each time I make a recording I lose many channels. Not always the same ones.
When I press Menu the Satalite option is greyed out and is the Diagnostics option.

I have two feeds from the LNB

Can ayone give me any guidance, is the box faulty or is the LNB at fault.

Steve
2479steve is offline   Reply With Quote
Please sign in or register to remove this advertisement.
Old 09-02-2010, 09:43
grahamlthompson
Forum Member
 
Join Date: May 2005
Location: Redditch Worcs
Posts: 17,289
Diagnostics is not available while the box is recording.

First check you have the two cables connected to the right connections (The 2 outer ones). IF wrong put right and do a factory reset, check you get the two cables found message during the reset. After the reset check diagnostics shows a good signal and quality on both tuners.

If you have only 1 signal swap the infeeds to comfirm it's a cable/lnb problem rather than the box.
grahamlthompson is offline   Reply With Quote
Old 09-02-2010, 09:47
GaseousClay
Forum Member
 
Join Date: Oct 2008
Location: Worcester
Posts: 4,185
welcome to the forum 2479steve
as Graham says try a factory reset. I'm betting in your eagerness to try the box out you connected just the one sat feed and then set the box up only to add the second feed later..
GaseousClay is offline   Reply With Quote
Old 09-02-2010, 19:31
2479steve
Forum Member
 
Join Date: Feb 2010
Posts: 7

Thanks Graham and Gaseous,

Does a factory reset lose the stored progammes on the hard disk. the wife will kill me if a I lose this lot as this happen when the Sky+ box stopped working
Steve
2479steve is offline   Reply With Quote
Old 09-02-2010, 19:42
GaseousClay
Forum Member
 
Join Date: Oct 2008
Location: Worcester
Posts: 4,185
Thanks Graham and Gaseous,

Does a factory reset lose the stored progammes on the hard disk. the wife will kill me if a I lose this lot as this happen when the Sky+ box stopped working
Steve
Your recordings will remain intact but you will need to do a freesat rescan and one for the non-freesat mode, re-enter your recording schedules and reset a couple of personal preferences. The box defaults to 50% volume so that will need ramping back up via the remote.
GaseousClay is offline   Reply With Quote
Old 09-02-2010, 20:45
2479steve
Forum Member
 
Join Date: Feb 2010
Posts: 7
Thanks Gaseous,

Before doing a reset. I did a test that was in an earilier thread to somebody else. It suggested to try recording Ch 104 and veiwing 137 as these are on the opposite polarities.
I tried this and it wouldn't allow me to veiw 137.
I'm not sure what this tells me, any help please
Thanks
Steve
2479steve is offline   Reply With Quote
Old 09-02-2010, 21:06
GaseousClay
Forum Member
 
Join Date: Oct 2008
Location: Worcester
Posts: 4,185
Thanks Gaseous,

Before doing a reset. I did a test that was in an earilier thread to somebody else. It suggested to try recording Ch 104 and veiwing 137 as these are on the opposite polarities.
I tried this and it wouldn't allow me to veiw 137.
I'm not sure what this tells me, any help please
Thanks
Steve
In simple terms it means that your not getting the full functionality from the two satellite inputs, but this could be for many reasons ie. faulty connections, dodgy LNB or just setting up the box without making the two feeds available before the box makes it's initial configuration.
What's inportant now is since the reset you can get full use from the two feeds.
The best test is to tune to BBC HD (108) and set the box to record manually then tune to BBC CI (951) again set a manual recording and then tune to anyother channel and see if you can pause the live playback.
GaseousClay is offline   Reply With Quote
 
Reply




 
Forum Jump


All times are GMT. The time now is 09:31.