My DTI-6300 has died and I need to open it to change the PSU capacitors, but I can't get it open.
I have removed the two screws, lifted the three clips, lifted the plastic screw hole out of the way but it will not slide out.
Have I missed anything?

I managed to do it in the end. Once it came out a bit I knew I was on the right track.

I had the same problem but just when i was loosing patience i dropped it and it all came apart! Lost a few 'snap on' clips but it's gone together ok...

Managed to change the dodgy capacitors, and the box is working fine - the exact same ones as I have read causes everyone's box to fail (16v 1000uF). Total repair cost £1.13!