DS Forums

 
 

DTI6300 upgrade from V2.0


Reply
Thread Tools Search this Thread
Old 08-12-2010, 10:10
Irish Pete
Forum Member
 
Join Date: Nov 2002
Location: Oxford
Posts: 260

I have an old DTI6300 which hasn't been used for some time. I've just reconnected it and have scanned for channels. It, however, has firmware V2.0. I've tried the "Force next OAD" option from the engineers' menu, but nothing happens when I press OK. I've also done a factory reset. It doesn't seem to be updating to 5.08. Is there any other way I can force a firmware OAD or am I stuck with 2.0?

Pete
Irish Pete is offline   Reply With Quote
Please sign in or register to remove this advertisement.
Old 08-12-2010, 10:35
SMURFIT
Forum Member
 
Join Date: Nov 2006
Location: Sussex, Heathfield.
Posts: 569
I have an old DTI6300 which hasn't been used for some time. I've just reconnected it and have scanned for channels. It, however, has firmware V2.0. I've tried the "Force next OAD" option from the engineers' menu, but nothing happens when I press OK. I've also done a factory reset. It doesn't seem to be updating to 5.08. Is there any other way I can force a firmware OAD or am I stuck with 2.0?

Pete
May i suggest that you leave the box on stand by and see what happens.
Normally it takes a little time for the box to update itself
SMURFIT is offline   Reply With Quote
Old 09-12-2010, 08:33
Irish Pete
Forum Member
 
Join Date: Nov 2002
Location: Oxford
Posts: 260
May i suggest that you leave the box on stand by and see what happens.
Normally it takes a little time for the box to update itself
I think it must be bust. It's been on for over 24 hours and still hasn't updated the firmware. I also can't force an OAD so perhaps the Flash Memory is corrupt?
Irish Pete is offline   Reply With Quote
Old 11-12-2010, 17:37
Scorpio
Forum Member
 
Join Date: Mar 2003
Location: Somerset
Posts: 3,048
My Dad's old 6300 wont scan for channels. I've done a full system reset and a disk reformat. I''ve even done a full reset with the disk unplugged(!!).
I've even plugged the aeriel cable into RFin 2 instead of RFin 1 but still can't get it to find any channels.
It goes through the motions (2 or 3 mins) but gets nowhere.
The signal is fine as the same aeriel cable will happily service my TV.

Any suggestions?

Rgds,
Scorp
Scorpio is offline   Reply With Quote
 
Reply




 
Forum Jump


All times are GMT. The time now is 09:52.