The box is over 2 years old and has the very latest updated Software..

I have unplugged it and auto scan a few times but still say`s no tv channels but it has radio channels. It has 100% quality and 70% signal. There is no engineering scheduled. My digihome pvr is working ok.

Any ideas ? Maybe the tuner at fault?

If it is picking up radio channels then it is unlikely to be a tuner fault. I would try a reset to default settings.

Ok i will try that!

Have you tried switching between the favourite channels lists. The Humax groups TV channels and radio channels into their own favourites lists automatically.

Press the tv/radio button located on the left of the bottom row of buttons under the remote contol's sliding flap.
This toggles between the radio and tv channels.

The 9150 remembers whether you were last on Radio or TV after retuning (unless you also do a default setting). But by far easiest thing to do is just to press the bottom left button on the remote. Using this button to switch from the Radio list to the TV list will retain your schedule and any favourites lists you have set up.

Thanks Luis that's what I meant to say. As I don't use the original remote (and hardly use the Humax at all now, and never to listen to the audio-only channels) I had forgotten how to do that. I'm sure the same can be achieved by going left/right through the favourites lists.

Thanks for all your help ! I did a default reset as Martin Liddle suggested and now is working. Ta !