I have just been to my Mum's to try and help her with the Humax PVR 9300T. I have checked cables, etc. I can get it to go but the 'sequence', as below, is to complicated for her to cope with. It goes like this -
1. Only see in the screen PVR 9300T (when that goes it can have a very, very small 576P at top right hand side in a way it is a blank screen.)
2. If I pull out the plug Humax will fire up and then I can switch on TV and select AV on TV remote.
3. Then can control TV with Humax.
4. Switch off TV and Humax - then not able to go through start up routine. Note: Time also missing on Humax screen.
5. So pull out plug and off I go again.
Any thoughts?
1. Only see in the screen PVR 9300T (when that goes it can have a very, very small 576P at top right hand side in a way it is a blank screen.)
2. If I pull out the plug Humax will fire up and then I can switch on TV and select AV on TV remote.
3. Then can control TV with Humax.
4. Switch off TV and Humax - then not able to go through start up routine. Note: Time also missing on Humax screen.
5. So pull out plug and off I go again.
Any thoughts?
.