Not quite a lockup but a bizarre happening.
The 9200 had been in stand by. I powered on but did not record anything.
I then attempted to show wife the new feature of dual buffering via PIP as documented by calamero. Pressed PIP and Hummy errored with "not allowed while recording"
To cut a long story short, Hummy would not respond 'normally'; switching into standby and then powering on brought Hummy to life instantly - no loading percentages screen.
Eventually, I had to cycle mains power using the switch at the back. Hummy then responded normally and showed loading screen and took its usual few seconds to start. Discovered a couple of 0Mb recorded programmes in the list which apparently have deleted OK.
Anyone else had anything like this?
The 9200 had been in stand by. I powered on but did not record anything.
I then attempted to show wife the new feature of dual buffering via PIP as documented by calamero. Pressed PIP and Hummy errored with "not allowed while recording"
To cut a long story short, Hummy would not respond 'normally'; switching into standby and then powering on brought Hummy to life instantly - no loading percentages screen.
Eventually, I had to cycle mains power using the switch at the back. Hummy then responded normally and showed loading screen and took its usual few seconds to start. Discovered a couple of 0Mb recorded programmes in the list which apparently have deleted OK.
Anyone else had anything like this?
