DS Forums

 
 

Video senders - to 2 TVs?


Reply
Thread Tools Search this Thread
Old 16-11-2007, 14:43
interpol
Forum Member
 
Join Date: May 2007
Posts: 15

Apologies if this is a dense question.

Video senders kits come with a "sending" box and a "receiving" box. If you bought another pair and attached only the "receiving" box to another TV would that set-up work.

ie. can you send a signal to multiple receiving boxes?

Can you buy just "receiving" boxes, so you don't waste money on a "sending" box that isn't used in the above example?
interpol is offline   Reply With Quote
Please sign in or register to remove this advertisement.
Old 16-11-2007, 15:21
niall campbell
Forum Member
 
Join Date: May 2006
Location: Aberfeldy
Posts: 7,035
http://www.maplin.co.uk/search.aspx?...d=-9&doy=16m11

please note that you would possibly need one that has more than 2 channels................. in case of interference, but you may be ok
niall campbell is offline   Reply With Quote
Old 16-11-2007, 15:34
interpol
Forum Member
 
Join Date: May 2007
Posts: 15
http://www.maplin.co.uk/search.aspx?...d=-9&doy=16m11

please note that you would possibly need one that has more than 2 channels................. in case of interference, but you may be ok
Cheers Niall.

Maplins seem to suggest there that you can buy one of their spare receivers (even if it's not the same brand as the existing transmitter and receiver already held) and that should work.
interpol is offline   Reply With Quote
Old 16-11-2007, 20:13
aerialview
Forum Member
 
Join Date: Nov 2007
Location: North West
Posts: 44
Or try a better priced bit of kit

http://www.aerialview.tv/scart.html

I know for sure that 1 sender and 2 receivers work from this unit providing they are on the same base channel, which is 1 of 4 user selectable channels.

Good luck

AV
aerialview is offline   Reply With Quote
Old 10-12-2007, 12:59
sarastew146
Forum Member
 
Join Date: Dec 2007
Location: Surrey
Posts: 1
We bought 2 identical sets of video senders (Giga air 2323) and have the transmitters plugged into the Cable box and the HDD/DVDR box in the living room. The 2 receivers are in the kitchen and bedroom.

Each pair (transmitter & receiver) have a choice of 3 channels. The cable box transmitter is permanently on channel 1 and the HDD on channel 3. The receivers can then be changed from 1 to 3 depending on which feed we want to watch.

It works brilliantly as there have been times when one of us has been watching Sky sports in the kitchen and the other watching a recording of Eastenders in the bedroom, but each feed has originated from the living room. There is no conflict or interference between them.

We do however get interference in the kitchen if the microwave is on (picture gets loads of horizontal lines and the sounds goes a bit watery) and sometimes the wireless router gives blips to the picture. I just unplug the router if that happens, it's not constant.

We're about to get a V+ box, so I may have to rethink my set up, or resign myself to constantly switching the V+ between HDMI and scart output, but we have found our A/V senders to be fantastic. (Having to put up with footie on the bedroom TV is the downside!)

Hope this helps!
sarastew146 is offline   Reply With Quote
Old 10-12-2007, 20:38
CWatters
Forum Member
 
Join Date: Jul 2006
Location: 18 miles from Sandy Heath
Posts: 382
One transmitter and two recievers should work fine but remember that on some systems the antenna can be quite directional. Hard to have it pointing in two directions at once.

Last time I tried a video sender the picture quality was very poor.
CWatters is offline   Reply With Quote
Old 10-12-2007, 22:58
TV DUNIYA
Forum Member
 
Join Date: May 2003
Posts: 6,622
You can buy extra receivers for av senders,but they are not cheap,often more than half the price of a full set(transmitter and receiver).
TV DUNIYA is offline   Reply With Quote
 
Reply




 
Forum Jump


All times are GMT. The time now is 06:23.